Application Instructions

Description: Step 1 - Clean the area thoroughly

Step 1
Clean the surface you are going to apply the decal to. Rubbing alcohol usually does the trick, but make sure you let it dry.

Description: Step 2 - Prepare the sticker for application

Step 2
Prepare the sticker for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape.

Description: Step 3 - Peel the white paper backing off

Step 3
Line the decal up where you want it to go
And Remove the backing paper

Description: Step 4 - Lower the sticker onto the surface

Step 4
Then take a hard item like a credit card or popsicle stick and rub it over the surface of the decal to make sure it is firmly sticking.

Description: Step 5 - Slowly peel the clear transfer tape off

Step 5
Start to pull off the transfer paper slowly at an angle.  If any part of the decal is not sticking, then rub it more with the credit card making sure there are no bubbles. Once again use the credit card to smooth it out and make sure it is stuck to the item.

Voila! Anything can be monogrammed with an easy to apply vinyl decal!


*Use a pin to poke any air bubbles in the center and push the air out through the hole.
*The recommended optimum temperature for applying graphics is 70°F. For best results do not apply a sticker in extreme hot or cold temperatures.

STILL NEED HELP? - Contact us at